To Upgrade Loko Air Firmware :

  1. download Loko Air firmware Link:
  2. Download STMCubeProgrammer Link
  3. Open STM32CubeProgrammer
  4. Connect Loko Air to PC via USB 
  5. on right side select UART. 
  6. select correct port on USB devices . 
  7. Parity select "None"
  8. Hit " Connect" button and wait to read Loko binary
  9. once it is connected to Loko microcontroller, hit " Erasing & Programming " section on left side bar.
  10. only check "Run after programming" 
  11. select file path of the new firmware
  12. hit " Start Programming" 
  13. wait until upload is complete. 
  14. Unplug the Loko Air unit . then turn off and on again to reset the device. 
  15. ready to use.

 

To Upgrade Loko Ground Firmware :

  1. install Thonny IDE Link
  2. download firmware Link
  3. Connect Loko Ground Unit to PC via USB
  4. turn on Ground unit by pressing button on device
  5. open thonny IDE
Вернуться к блогу